Home Improvement

Step by step instructions on how to make an air conditioner using parts that cost less than $40.

Cheap way of having a cinema in you room! without shelling out hundreds of pounds!!!

www.bubzbeauty.com http MY DAYS! Half a year since I did a DIY facial mask tutorial!!!! What can I say guys? Natural is the way to go for skincare! ^_^ This mask/toner remedy has many skin benefits such as: Scar reducing Treats blemishes Refines Pores Unclogs Pores Firms the skin Anti-ageing Anti inflammatory Skin brightener Skin detoxer Cleanser Moisturising benefits This mask/toner is frickin incredible guys!!! I LIKE IT!! My Jewelry (earrings- necklace and bracelets lol) are all from DSK Jewelry: www.dskjewelry.blogspot.com Stay well bubbiful ones Much like, Bubbi xx

There are different types of rust or corrosion. Galvanic Corrosion

This takes place when two dissimilar metals are submerged in water. These metals become like a Battery, one metal acts as the positive side of the battery and the metal become the negative side of the battery and then generates small electrical current flowing from one metal to the other, it eats away at the weaker of the two metals

Electrolytic Corrosion.

This is caused by currents from outside your boat, such as leakage from your shore-power system or a mild electrical current from a nearby boat.

Rust Corrosion.

Iron and steel will get that common reddish-brown rust wherever bare metal is exposed to any type of dampness.

Pitting Corrosion.

Aluminum doesn’t “corrode” but rather forms a layer of oxidation on the surface that looks like small dull grime with whitish lumps.

Some steps to take in slowing or stopping Rust or Corrosion are:

One method to stop the Galvanic and Electrolytic Corrosion is by using a system of Zinc Anodes.
The Zinc Anodes should be bolted to the out-drive, rudders, prop shafts, trim tabs and all other areas of metal that could be attacked. The Zinc Anodes are sacrificial and they will be eaten away before the corrosion can get into your more expensive metal parts of your boat.

For Galvanic Corrosion can also be eliminated by keeping dissimilar metals apart. Mounting an aluminum fitting with a bronze bolt is asking for distress, which is why stainless-steel bolts are commonly used for boating gear. If you have to replace a metal fitting with a dissimilar metal, you must insulate the two metals from each other with a layer of electrical or rubber tape.

A method to stop Common Rust is in prevention by coating all the parts with ZIRLON to keep them protected from the wet and dampness. If it’s already started to rust, you can’t just paint over it since the rust will continue to blossom under a layer of paint that will soon blister off. Instead, use a wire brush, bronze wool (not steel wool, which leaves pieces that will rust!), or sandpaper to get down to bare metal, apply a coat of ZIRLON.

Another method to stop Aluminum Corrosion, really to stop Aluminum Oxidation is to protect it with ZIRLON before oxidation starts. Once it has that grayish film, which is really oxidation, has shown up you need to sand it off or use a specialized aluminum restoration product that will clean the surface .Then protect the parts with ZIRLON. With ZIRLON the aluminum will remain a honestly high maintenance item on your boat.

The other metal is Stainless Steel. Even with its name, stainless steel isn’t stain-less. You have frequently seen weepings or runs of rust on a stainless-steel. Even stainless steel can bleed a small corrosion. Using wax can help protect the stainless steel but ZIRLON in the beginning is a long time protection that you can use to prevent it from starting.

Is your boat being attacked by Galvanic or Electrolytic Corrosion?

Look for galvanic or electrolytic corrosion in the pitting of your Zinc Anodes. Another way to tell when you are being attacked is when your metal parts turn pinkish in color. When checking your Zinc Anodes and you see a high rate of reaction or the disappearing of the Zinc, call in an experienced electrician to see if your boat is leaking the stray currents or if your marina and nearby boats are at fault.

Zirlon Marine is a designer nano-technology now with an atomic charged molecule technology. It was design for as an anti-fouling for boat hulls but it can also be used on any metal to prevent corrosion. Zirlon Marine is also 100% environmentally safe and able to perform above any of global leading “green” standards.

Tip: Coat all of your Electrical Connections with Zirlon – you will be pleased that you did… Visit www.kinlochglobal.com

Many people say that the tap water all over the world it is not safe for drinking. They I right. Research studies conducted all over the world show that the water contains harmful chemicals.

Even in the major cities in the States the water can not be drank safely.

I had to reconsider my option of drinking tap water. It is not safe. Then I did a market study and saw the prices on the water. I was frightened when I saw the result. A family that buys bottled water to drink spends around 3000 dollars a year just for that. I chose to look for other ways to get safe and clean water.

If it was possible, a less expensive way to do that. After a small period of time I learned that using a tap water filter helps me eliminate the perilous bacteria and debris from the water. The filter even eliminates the heavy metals and the parasites. But still, many of the filters were expensive and even hard to use. I had a problem. Some filters are so accurate about cleaning the water that they even remove some excellent minerals in the tap water.

And that can hurt our health. The recent studies have clearly shown that the lack of minerals in the water can cause many and serious diseases.

This is the reason why you need to know what the filter at your home does precisely. If yours removes 95% of the heavy metals in the water, don’t use it. It will eliminate the excellent minerals also. I wish this article has provided you with some helpful information on how to deal with the problem of having safe water.